Publicité
Les langues disponibles
Les langues disponibles
Ice Maker and Storage Bin
IMPORTANT: Flush the water system before turning on the ice
maker. Allow 24 hours to produce the first batch of ice. Discard
the first three batches of ice produced. Allow 3 days to completely
fill the ice container.
To Turn the Ice Maker On/Off:
The On/Off switch for the ice maker is a wire shutoff arm located
on the side of the ice maker.
1. To turn the ice maker on, simply lower the wire shutoff arm.
NOTE: Your ice maker has an automatic shutoff. As ice is
made, the ice cubes will fill the ice storage bin and the ice
cubes will raise the wire shutoff arm to the OFF (arm up)
position.
2. To manually turn the ice maker off, lift the wire shutoff arm to
the OFF (arm up) position and listen for the click to make sure
the ice maker will not continue to operate.
Ice maker cover
To Remove and Replace the Ice Storage Bin:
1. Flip up the covering panel.
A
B
A. Ice maker cover
B. Ice bin
2. Lift the wire shutoff arm so it clicks into the OFF (up) position.
Ice can still be dispensed, but no more can be made.
3. Lift up the front of the storage bin and pull the ice bin forward.
4. Replace the bin by pushing it in all the way or the dispenser
will not work. Push the wire shutoff arm down to the ON
position to restart ice production. Make sure the door is closed
tightly.
Refrigerator Operation
Clean the Ice Storage Bin
NOTE: It is normal for ice to stick together in the ice bin. Ice may
be dispensed or used more frequently which will break up the ice.
It is recommended that the ice container be emptied and cleaned
as needed.
To clean the ice storage bin:
1. Empty the ice container. Use warm water to melt the ice if
necessary.
NOTE: Do not use anything sharp to break up the ice in the
bin or bucket. This can cause damage to the ice container and
the dispenser mechanism.
2. Wash the ice bin with a mild detergent, rinse well and dry
thoroughly. Do not use harsh or abrasive cleaners or solvents.
IMPORTANT:
„ Allow 24 hours to produce the first batch of ice. Allow 3 days
to completely fill ice container.
„ Discard the first three batches of ice produced to avoid
impurities that may be flushed out of the system.
„ The quality of your ice will be only as good as the quality of
the water supplied to your ice maker.
„ Avoid connecting the ice maker to a softened water supply.
Water softener chemicals (such as salt) can damage parts of
the ice maker and lead to poor quality ice. If a softened water
supply cannot be avoided, make sure the water softener is
operating properly and is well maintained.
„ It is normal for the ice cubes to be attached at the corners.
They will break apart easily.
„ Do not force the wire shutoff arm up or down.
„ Do not store anything on top of the ice maker or in the ice
storage bin/bucket.
6
Publicité
