Jenn-Air JBC2088HTB Guide D'utilisation Et D'entretien page 14

F
RESH
Shelves
To avoid personal injury or property damage,
observe the following:
• Never attempt to adjust a shelf that is loaded with
food, except in the case of the Elevator
• Confirm shelf is secure before placing items on
shelf.
• Handle tempered glass shelves carefully. Shelves
may break suddenly if nicked, scratched, or
exposed to sudden temperature change.
Your refrigerator has either Spillsaver™ or non-sealed
shelves. Spillsaver™ shelves have a spill retainer edge
which allows for easier clean up and some are
equipped with a roll out feature. To roll out (select
models), grasp the front of the shelf and pull forward.
Push in the shelf to return to the original position.
To Remove a Shelf:
• Slightly tilt up the front and lift up
the rear of the shelf, then pull the
shelf straight out.
To Lock the Shelf Into Another Position:
• Tilt up the front edge of the shelf.
• Insert the hooks into the desired frame openings and
let the shelf settle into place.
• Be sure the shelf is securely locked at the rear.
The Crisper Top serves as the lower fresh food shelf.
To Remove the Crisper Top:
• Remove crisper drawers as indicated on page 14.
• Place hand under the frame to push up the glass. Lift
glass out.
• Lift frame from refrigerator liner rails.
• To install, repeat above instructions in reverse order.
Full-width Door Shelf
Full-width Door Shelf removes for easy cleaning.
To Remove:
• Slide shelf up and pull
straight out.
To Install:
• Reverse above
13 procedure.
F F
OOD EATURES
CAUTION
TM
(select models)
Door Storage
Dairy Center
The Dairy Center provides
convenient door storage for
spreadable items such as butter and margarine. This
compartment can be moved to different locations to
Shelf.
accommodate storage needs. To use the dairy
compartment, raise the cover.
To Remove:
• Raise the cover, pull upward and tilt out.
To Install:
• Reverse above procedure.
Door Buckets
Door Buckets can be moved to meet
storage needs.
To Remove:
• Slide bucket up and pull straight
out.
To Install:
• Slide bucket in and down until firmly seated in the
door liner.
Beverage Chiller™
(select models)
The Beverage Chiller™ keeps
beverages and other items cooler than
the rest of the fresh food section. A cold
air inlet allows air from the freezer
section to pass into the beverage chiller.
The Beverage Chiller™ control is located
on the left wall of the fresh food
compartment. The control adjusts the
amount of cold air allowed in to the
beverage chiller. Turn the control
clockwise for a colder temperature.
To Remove Beverage Chiller:
• First remove the pick off shelf to
the left of the Beverage Chiller.
• Firmly hold each side of beverage
chiller, lift up and away from door
liner.
To Install Beverage Chiller:
• Reverse above procedure.