Publicité
EN
Watch out for falling branches!
Walk! Do not run! As soon as a branch being cut off starts cracking and falling down, move to the side immediately and keep safe distance from the falling
wood as It can hurt back up and cause Injuries.
Switch the appliance immediately off and remove the replaceable battery from the appliance when the saw chain gets blocked. Remove the blocked object.
When working, keep the appliance firmly with both hands and with a distance from your body.
Make sure the appliance is off before inserting a battery.
The ON/OFF switch and safety switch must not be locked.
Before using, check the tightness and proper seating of all screwed and socket joints and protective equipment and if all moving parts are moving smoothly.
It is strictly prohibited to demount, adjust and alienate the protective equipment on the machine or put other protective equipment on the machine.
Do not use the appliance if damaged or the safety equipment is defective. Replace any worn and damaged parts.
Do not use the device near flammable liquids or gases. Risk of fire and explosion in case of short circuit.
Warning! This electric tool generates a magnetic field.
In some circumstances, this field may disrupt the functioning of medicated implants assets or liabilities. In order to reduce the risk of injury serious or fatal,
we recommend that people wearing a medical implant to consult a doctor and manufacturer of the medical plant before use of the device.
Battery
Vapours may leak out In case of unauthorised use or when using a damaged battery. Bring fresh air and seek medical advice if experiencing difficulties.
Vapours may irritate the respiratory system.
Risk of fire! Risk of explosion!
Never use damaged, defective or deformed batteries.
Never open or damage the battery or let It fall on the ground.
Never charge the battery in an environment with acids and easily flammable materials.
Protect the battery against heat and fire.
Never put the battery on heaters and do not expose It to strong sunlight for a long time.
After being subject to heavy load, let the battery cool down first.
Short circuit- do not bridge the battery contacts with metal parts.
The battery must be packaged (plastic bag box) or battery contacts must be sealed up for battery disposal, transport or storage.
Description of main parts (Picture A)
1. Cutting chain
3. Guide bar
2. Chain tensioner
4. Safety button
Charging batteries
Warning: Use only the original charger to charge the batteries supplied by the manufacturer. Only batteries and chargers designed by Bormann can be used in
conjunction with this product.
The use of any other types of batteries / chargers in combination with this product is considered abuse and will void the warranty.
Once connected to the power supply, the battery can be recharged without the need for monitoring. The complex construction of the circuit monitors the
condition of the battery by adjusting the recharge current to match the requirements. When the recharge cycle is complete and to maintain full capacity, a
low-voltage output current will continue to be powered as needed.
Warning!
• Check the status of the charger and battery before each charge. If there is any indication of a fault then do not continue, seek advice from an authorized
vendor.
Battery pack efficiency and charging advice
Recharge the battery packs before they become completely exhausted
When you feel that the power of the tool becomes weaker, stop using the tool and recharge the battery packs. If you continue to use the tool and exhaust the
electric current, the battery pack may become damaged.
Avoid recharging at high temperatures. A rechargeable battery pack will be hot immediately after use. If such a battery pack is recharged immediately after
use, its internal chemical substance will deteriorate, and the battery life will be shortened. Leave the battery pack and recharge it after it has cooled for a while.
The battery pack should only be used and/or charged when battery pack temperature is between 50C and 300C.
The battery pack needs to be warmed-up or cooled down in order to prevent damage to the batteries internal components.
Note: Failure to warm up or cool down a battery pack could result in serious damage to tie battery, charger and user.
17
5. ON/OFF trigger
WWW.NIKOLAOUTOOLS.GR
Publicité
