emerio HO-121844.1 Mode D'emploi page 6

HO-121844.1
DESCRIPTION
1. Heating elements
2. Handle
3. Thermostat knob
4. Power switch
5. Wheel
6. Cord storage
7. Indicator light
WHEELS ASSEMBLY
1. Assemble the four wheels to the two base shelves.
2. Turn the heater upside down.
3. Position the wheel base assemblies between the end fins.
4. Traverse the clips through the appliance body and base shelves.
5. Tighten the screw.
Using the Appliance
Set the thermostat knob to the minimal position and insert the plug to the power supply.

Press the power switch: I=1000W; II=1500W; I+II=2500W

Turn the thermostat knob in a clockwise direction to the max position. The indicator light will illuminate.

Once the room temperature has reached the desired value, turn the thermostat knob slowly in

anti-clockwise direction until you hear a "click" sound; this is the setting temperature.
The appliance will automatically maintain the setting temperature. It will switch on when the room

temperature is below the setting, and switch off if it is above the setting.
NOTE:
The room must be in a good tight condition; if not, the heating results will be insufficient.

After use, turn the thermostat to the minimal position and unplug the appliance from the power supply.

SAFETY SYSTEM:
The appliance has a safety system which automatically switches the unit off when overheated.

If overheating occurs, remove the plug from the socket, push the buttons to switch the unit off and let it

cool down for at least 10 minutes. Put the plug in the socket and switch the heater on.
This heater is equipped with a tilt protection safety device. It has tilt protection safety functions and

automatically switches off the power. For safety reasons, the unit will automatically switch off the power if
it is put on unstable or uneven surfaces or if it is tilted accidentally.
- 5 -
EN