Hiltron security FBX2 Mode D'emploi page 7

security
Installation example Installation example
min. min.
50cm 50cm
T T T T T T
R R R R R R
Barriers side by side Barriers side by side
Connecting cables before the definitive assemblage of the wall unity
external installation
*Protect your infrared barrier from dampness
or wet weather, such as rain, snow, and fog.
In external installation is better to use some
drops of silicone on a side of the section to
seal possible spray of water .
T T
R R
T T
R R
T T
R R
Barriers consecutive Barriers consecutive
Removing the cap
from the circuit connector
FBX2-FBX4-FBX6-FBX8 - User's manual
min. min.
Morsettiera Morsettiera
50cm 50cm
T T
R R
R R
Correct Correct
Installation Installation
Maximum gap Maximum gap
Outdoor: 8m Outdoor: 8m
T T
Indoor: 16m Indoor: 16m
3B
Passing the cable
as in figure
(It is recommended
3B cable)
Doing the connections
NOTE: Install barriers NOTE: Install barriers
so that so that
cables always escape cables always escape
from the superior side. . from the superior side. .
If it is necessary, using If it is necessary, using
some drop of silicone some drop of silicone
to avoid water entering. to avoid water entering.
3B
3B
3B
as in figure
Reassembling the cap with
the cable connected to the terminal box.
in the guides of the section and
pushing completely the cap
3B
Inserting the circuit
7 7