WAGNER WallPerfect W 925 E Manuel D'utilisation page 33

WallPerfect W 925 E
11 Air hose
12 Securing clip
13 Material hose and control hose *
14 Complete suction hose
15 Air filter cover
16 Air filter (2x)
Lubricating grease
* Denotes parts that can only be purchased together and not individually.
Further information about the WAGNER range of products for renovating is available
under www.wagner-group.com
Correction of Malfunctions
Problem
No coating material
emerges from the
nozzle
Coating material
drips from the
nozzle
Spare Parts List (Fig. 15)
Cause
•
When trigger is not
completely pushed through,
the feed pump is not
switched on
•
Control hose blocked or
damaged
•
Nozzle clogged
•
Material volume setting
turned too far to the left
•
Container empty
•
Suction hose is blocked
•
The suction hose is
disconnected from the basic
device
•
The suction hose is not in
the paint
•
Pull wire is disconnected or
not tight enough
•
The material hose is
disconnected from the spray
head or basic device
•
Pump is defect
•
Coating material assembly
at air cap, nozzle or needle
•
Nozzle loose
•
Nozzle seal worn
•
Nozzle worn
•
Pull wire is too tight
2311 331
2308 123
2311 327
2308 116
2311 345
2310 812
9892 550
Remedy
Push trigger through
➞
completely
Clean or replace
➞
Clean
➞
Turn to the right
➞
New paint container
➞
Clean suction hose
➞
Reattach the suction hose
➞
Immerse the suction hose
➞
Connect and tighten the
➞
pull wire
Reattach the material hose
➞
Please contact Wager
➞
Service
Clean
➞
Union nut tighten
➞
Change
➞
Change
➞
Reduce tension
➞
GB
25