Perel LEDA4001 Serie Mode D'emploi page 7

Mounting the Lamp
1. This luminaire does not have a built-in device to disconnect it from the
electric mains. Make sure to electrically isolate the luminaire before
installation or maintenance activities are performed.
2. Use the mounting bracket [1] to determine the location of the mounting
holes.
3. Drill the holes and secure the bracket using screws and wall plugs.
4. Connect the power cable [4] to a suitable junction box (not incl.). Make
sure the connection is properly earthed. Make sure there is no strain on
the cable; leave sufficient slack.
Warning: if the power cable is damaged, it must be replaced by the
manufacturer, his service agent, or a similar qualified person in order to
avoid any hazard.
5. To point the lamp in the desired direction: loosen the hinges [2] using a
hex key.
6. Tilt the lamp in the desired angle and tighten the hinges.
7. Cleaning and Maintenance
 All screws should be tight and free of corrosion.
 The housing, the visible parts, the mounting supports and the installation
location (e.g. ceiling, suspension, trussing) should not be deformed,
modified or tampered with; e.g. do not drill extra holes in mounting
supports, do not change the location of the connections...
 Mechanically moving parts must not show any signs of wear and tear.
 The electric power supply cables must not show any damage. Have a
qualified technician maintain the device.
V. 01 – 25/11/2015
LEDA4001 Series
N = neutral, blue
E = earth, yellow/green
L = line, brown
7 ©Velleman nv