Télécharger Imprimer la page

Hoover DYNAMIC DRY DYH 9813NA2X Manuel D'instructions page 11

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 74
The water removed from the laundry during
the drying cycle is collected in a container
inside the door of the dryer. When the
container is full the
panel will light, and the container MUST be
emptied. However, we recommend that the
container is emptied after each drying cycle.
NOTE: Very little water will collect during the
first few cycles of a new machine as an internal
reservoir is filled first.
To Remove the Container
1. Gently pull out the
w a t e r c o n t a i n e r
holding the handle.
When it is full the
water container will
weigh about 6 kg.
2 . Ti l t t h e w a t e r
container to empty the
water out through the
spout.
When empty, replace
the water container
back as shown; first
insert the base of the
container into position
as shown then gentle
push the top into
position.
3. Press
Button to
restart the cycle.
NOTE: If you have the
option of drainage
near to the dryer you
can use the discharge
k i t t o p r o v i d e a
permanent drainage
for the water collected
in the container of the
dryer. This means that
you don't have to
e m p t y t h e w a t e r
container.
WARNING! If you open the door mid cycle,
before the cool-down cycle has completed,the
handle may be hot. Please use extreme caution
when attempting to empty the water reservoir
during the cycle.
indicator on the control
1
WATER CONTAINER
OPERATION
1.
Open the door and load the drum with
laundry. Ensure that garments do not hinder
closure of the door.
2. Gently close the door pushing it slowly until
you hear the door 'click' shut.
3. Turn the Programme Selector dial to select
the required drying programme (see
Programme Guide).
4. If drying synthetics, acrylics or delicate items,
press the
button to reduce the heat level.
The indicator will light up when the machine is in
low heat setting. To deselect in the first few
minutes of the programme, press the
, after this time reset the machine to change the
setting.
5. Press the
button. The dryer will start
automatically and the indicator above the
button will be continuously lit.
6. If the door is opened during the programme to
check the laundry, it is necessary to press
recommence drying after the door has been
closed.
7. When the cycle is nearing completion the
machine will enter the cool down phase, the
clothes will be tumbled in cool air allowing the
load to cool down.
8. Following the completion of the cycle the
drum will rotate intermittently to minimize
creasing. This will continue until the machine is
switched OFF or the door is opened.
Do not open the door during the automatic
programs in order to obtain a proper drying.
button
to
EN 11

Publicité

loading