Futurelight PSX-250 DMX-Scanner Mode D'emploi page 50

- Main menu 5
• Press [MODE/ENTER] to enter the main menu (display flashing).
• Press [UP] to select "EDIT".
• Press [MODE/ENTER] to enter editing for the selected channel , the fixture reacts to your settings. The
display shows the DMX value of the edited channel. Such as " 11XX", it stands for channel 11 of the current
scene, the DMX value is XX , XX is a hexadecimal number value "01-FF".
• Adjust the desired DMX value by pressing [UP] or [DN].
• Press [MODE/ENTER] in order to edit other channels of this scene.
• Repeat above steps until you finish setting all the DMX values for all channels of this scene.
• Once all the channels completed, the display will flash "TIME".
• Press [MODE/ENTER] to edit the time needed, the display shows "TXXX", "XXX" stands for the time
needed to run the current scene, value "001-999". For example, "T002" means you need 0.4 ms (002 x 0.2
ms) to run the current scene.
• Adjust the desired time by pressing [UP] or [DN].
• Press [MODE/ENTER] to save the settings for the scene you are editing, the display will change to the next
scene automatically.
• Repeat above steps to edit and other scenes, you can edit and save a maximum of 48 scenes.
• Press [EXIT] to exit. The number of steps can be defined under "STEP" and the scenes can be called up
under "RUN"
- Define the number of steps in Run
With this function you can define the number of steps in the
Program Run.
• Select "STEP" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows"S-XX", "X"
stands for the total amount of steps you want to save, so
you can call up to 48 scenes in "RUN". For example if the
"XX" is 05, it means that "RUN" will run the first 5 scenes
you saved in "EDIT".
• Press [MODE/ENTER] to save and exit.
- Auto scenes rec
With this function you can automatically record new
scenes.
• Select "REC" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows"RE-XX", "X"
stands for the total amount of memorizable scenes, you
can call up in "RUN". For example if the "XX" is 05, it
means that "RUN" will run the first 5 scenes you saved in
"EDIT".
• Press [MODE/ENTER] to save and exit.
- Editing the channels of the individual scenes
With this function you can edit the program to be called up
in Run.
a) Editing via the Control Board
• Select "SC01" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "SCXX", "X"
stands for the scene no. to be edited.
• Change the scene no. by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "C-XX", "XX"
stands for the channel no. Such as "C-01", it means you
are editing channel 1 of the selected scene.
• Select the channel no. you would like to edit by pressing
[UP].
50/102 51839925_V_1_3.DOC