RIB AA40833C Mode D'emploi page 51

ALLEN KEY LOCK UNLOCKING RELEASE
It is also possible to release the locking device from the outside using auxiliary device code
ACG8732 and customised key.
For the assembly see the accessory specific instructions.
Follow the simple operations described below in order to carry out unlocking operations:
- Remove the lock barrel with the appropriate key (Pic. 76).
ATTENTION!
The coupling of the releases with closed door doesn't guarantee the total closing of the door. It will partially remain opened until an electrical movement. The corrected closing will only happen
with electrical closing completed.
MAINTENANCE
To be undertaken only by specialized staff after disconnecting power supply.
Grease the fulcrums, the counterweight channels, the telescopic levers and carry out the necessary impacts force check as for EN 12453 once a year.
- Insert an allen wrench (no. 6) in the hole of the plate as far as the release device bushing
(Pic. 77).
- Turn the hexagonal key in the direction indicated on the sticker on the up-and-over door
until the operator unlocking device is activated (Pic. 78).
- In order to lock the reducer, turn the hexagonal key in the direction indicated on the sticker
on the up-and-over door (Pic. 78).
75
BOSS MASTER
77
RELEASE
51
G
B
76
78