Light Replacement - Franke FCR 708-H TC Mode D'emploi Et Installation

Table des Matières

Les langues disponibles

This filter cannot be washed or regenerated. It must be replaced when the C appears on the

display or at least once every 4 months. The filter saturation alarm has to be activated already

before.

Activation of the alarm signal

• In the recycling version hoods the filter saturation alarm must be activated during the instal-

lation or later.

• Switch off the hood and the lights.

• Press the E-key for about 5 seconds until the last two segments of the motor LEDS are lit on

the display.

• By releasing the E-key the clock icon starts to flash.

• Within 3 seconds press the D-key to activate/deactivate charcoal filter saturation alarm.

• C-symbol lit - charcoal filter saturation alarm ACTIVATED.

• C-symbol unlit - charcoal filter saturation alarm DEACTIVATED.

CHANGING THE ACTIVATED CHARCOAL FILTER

Resetting the alarm signal

• Press button G and hold it for at least 2 seconds.

Changing the Filter

• If closed, open the Carriage by pressing button A and holding

for at least 1.5 seconds (see USE).

• Open the comfort panel.

• Remove the grease filters.

• Remove the saturated Activated Charcoal Filters, as indicated

(A).

• Fit the new Filters, as indicated (B).

• Replace the metal grease filters.

• Close the comfort panel.

20 W halogen light.

• Extract the lamp from the lamp holder by pulling gently.

• Replace with another of the same type, making sure that the two

pins are properly inserted in the lamp holder socket holes.

Charcoal filter (recycling version)

Lighting

LIGHT REPLACEMENT

Table des Matières