Télécharger Imprimer la page

Krups SAVOY ET451 Mode D'emploi page 10

Masquer les pouces Voir aussi pour SAVOY ET451:

Publicité

Les langues disponibles

Les langues disponibles

■ Press the CLEAN button (o) and then the BREW/control knob (k) to start the descaling cycle. Fig. 29.
■ The cycle lasts for 30 min.
■ Please wait until the end of the cycle.
■ If the water tank is not empty, please launch another descaling cycle by pressing CLEAN button.
■ To rinse the machine, run 2 full 12 cups cycles with water but without coffee. Fig. 30.
■ Repeat the operation if needed.
■ Replace the filter cartridge. Fig. 34 and 35.
■ The warranty does not cover coffee makers that do not work, or do so poorly, due to lack of
descaling.
DUO FILTER CARTRIDGE
■ Your appliance allows you to filter with the DuoFilter filters : double action filter – reduces chlorine and
scaling – based on active plant ingredients. This Duo Filter allows you to enjoy the most delicate aromas
of your coffee and reduces the need to descale.
■ In its upper part, the filter cartridge support is equipped with an indicator for replacement of the cartridge.
■ Select the number of the month when you replaced the filter. It will display the month when you should
change your filter according to water hardness. Fig. 33.
■ To change the filter, remove the DuoFilter from the tank. Fig. 32.
■ Open it by unlatching and opening the lower part and replacing it. Fig. 34.
IMPORTANT :
The DuoFilter filter must only be used with water.
Your coffee maker operates even if the water filter is not installed.
If you have not used your coffee machine for over a month, rinse the DuoFilter filter under
running water.
It is recommended not to leave the DuoFilter water filter in place for over 5 months.
The duo filter can cause the water to flow slow, excess steam, high noise level. The filter may
need to be replaced.
9. TROUBLESHOOTING
PROBLEM
The coffee does not BREW
or the appliance does not
turn on.
The appliance seems to leak.
Brewing takes a long time.
12
SOLUTION
■ Make sure the appliance is plugged into a working outlet and the
screen flashes.
■ The water tank is empty.
■ There is a power outage.
■ Unplug the machine, then plug it back in.
■ The clock should be reprogrammed after a power outage.
■ The automatic stop feature has turned off the appliance. Turn off the
appliance and then turn it back on to make more coffee. For more
information, please consult the "Making Coffee" section.
■ Make sure the water tank has not been filled beyond the maximum
limit.
■ It may be time to descale the appliance.
■ Several minerals can accumulate in the coffee maker's circuitry.
Regular descaling of the machine is recommended. This may need to
be done more often depending on the hardness of your water. For
more information, please consult the "Descaling" section.
CAUTION: do not take the appliance apart.

Publicité

loading