Publicité
Les langues disponibles
Les langues disponibles
TROUBLESHOOTING
Problem
Toaster does not heat and the
conveyor belt does not move.
Toaster heats and the conveyor belt
does not move.
Top or bottom heater tubes do not
heat.
Toaster repeatedly overheats.
The fan is not running.
The toaster is turned off and the fan
is running.
6
Dual Conveyor Convertible Toasters, Up to 1,100 Slices Per Hour* Operator's Manual - Models JT2HC and JT3HC
Might be Caused By
Toaster is not plugged in.
Power knob setting is incorrect.
The wall breaker may be tripped.
The reset may be tripped.
There may be a problem with the motor/
speed control or drive chain.
One or more heater tubes may have
burned out.
Heat control switch may be broken.
The crumb tray may not be installed.
The fan may be dirty.
There may be a problem with the fan.
There may be a problem with the fan or
the fan switch.
Normal operation. The fan turns on as
needed to cool the toaster.
Course of Action
Plug in the toaster.
Rotate the power knob to the ON (|) position.
1. Inspect for tripped breaker.
2. Reset the breaker.
3. If the breaker was not tripped, inspect the toasting chamber for
broken heat tubes.
For broken tubes, contact Vollrath Technical Services.
Look under the toaster to see if an object is preventing the fan
blades from turning.
1. Rotate the heat control knobs to the OFF position.
2. Rotate the power knob to the OFF (O) position.
3. Unplug the toaster.
4. Wait 30 minutes for the toaster cool.
5. Remove the object.
6. Plug in the toaster.
7. Rotate the power knob to the ON (|) position.
8. Press the reset button. You should hear and feel the button
reset. The toaster should start to operate.
9. If the problem persists call Vollrath Technical Services.
Inspect the fan blades to see if they are dirty.
1. Rotate the heat control knobs to the OFF position.
2. Rotate the power knob to the OFF (O) position.
3. Unplug the toaster.
4. Wait 30 minutes for the toaster cool.
5. Clean the fan blades.
6. Plug in the toaster.
7. Rotate the power knob to the ON (|) position.
8. Press the reset button.
9. If the problem persists call Vollrath Technical Services.
Contact Vollrath Technical Services.
Contact Vollrath Technical Services.
Verify the crumb tray is installed.
Verify the fan blades are clean. See instruction above for inspecting
and cleaning the fan blades.
Run the toaster for 10 minutes. If the fan does not run, contact
Vollrath Technical Services.
Run the toaster for 10 minutes. If the fan does not run, contact
Vollrath Technical Services.
_
Publicité
