Nexgrill 720-0958AE Instructions D'opération page 9

GENERAL USE OF THE GRILL AND ROTISSERIE
Each main burner is rated at 12,000 BTU/hr. The main grill
burners encompass the entire cooking area and are side
ported to minimize blockage from falling grease and debris.
The knobs are located on the lower center portion of the
control panel. Each knob is labeled on the control panel.
USING THE GRILL
Grilling requires high heat for searing and proper browning.
Most foods are cooked at the " " heat setting for the entire
cooking time. However, when grilling large pieces of meat or
poultry, it may be necessary to turn the heat to the lower
setting after the initial browning. This cooks the food through
without burning the outside. Foods cooked for a long time or
foods basted with a sugary marinade may need the lower
heat setting near the end of the cooking time.
NOTE: This grill is designed to grill efficiently without the
use of lava rocks or briquettes of any kind. Heat is radiated
by the stainless steel flame tamers positioned above each
burner.
WARNING: IMPORTANT!
BEFORE LIGHTING
Inspect the gas supply hose prior to turning the gas "ON". If
there is evidence of cuts, wear, or abrasion, it must be
replaced prior to use. Do not use the grill if the odor of gas is
present. Only the pressure regulator and hose assembly
supplied with the unit should be used.
Never substitute regulators and hose assembly for those
supplied with the grill. If a replacement is necessary, contact
the manufacturer for proper replacement. The replacement
must be that specified in the manual.
WARNING
Always keep your face and body as far away from the
burner as possible when lighting.
TO LIGHT THE MAIN
Make sure all knobs are off then turn on the gas supply from
the LP (Liquid Propane) tank. Always keep your face and
body as far from the grill as possible when lighting.
To light your main burner, push and turn main burner control
knob to , at the same time, press and hold electronic
ignition button to light the burner. Once the burner is lit,
release the electronic ignition button and knob. If the burner
does not light wait 5 minutes for any excess gas to dissipate
and then retry.
TO LIGHT THE SEAR BURNER
To light the sear burner, remove any cooking utensils from
the burner grate. Push and turn the control knob to
the same time, press and hold electronic ignition button to
light the burner. Once the burner is lit, release the electronic
ignition button and knob. If the burner does not light, turn
the control knob to "○". If the smell of gas is detected and
the igniter is not functioning, immediately turn the control
knob "○". Allow 5 minutes for any accumulated gas to
dissipate. If the sear burner igniter is not functioning, see
the following section for match lighting.
NOTE: The hot grill sears the food, sealing in the juices. The
more thoroughly the grill is preheated, the faster the meat
browns and the darker the grill marks.
DO NOT LEAVE THE GRILL UNATTENDED WHILE
COOKING.
WARNING: IMPORTANT!
USING THE SEAR BURNER
Inspect the gas supply hose prior to turning the gas "ON". If
there is evidence of cuts, wear or abrasion, it must be
replaced prior to use. Do not use the sear burner if the odor
of gas is present.
Keep a spray bottle of soapy water near the gas
supply valve and check the connections before
each use.
Do not attempt to light the grill if odor of gas is
present. Call for service 1- 866-984-7455 in USA
and 1-800-648-5864 in Canada, language spoken:
English, French, Spanish 8 a.m.-5 p.m., PST.
Monday-Friday.
Each burner is adjusted prior to shipment;
however, variations in the local gas supply may
make minor adjustments necessary.
Place dust cap on cylinder valve outlet when the
cylinder is not in use. Only install the type of dust cap
on the cylinder valve outlet that is provided with the
cylinder valve. Other types of caps or plugs may result
in leakage of propane.
The gas must be turned off at the supply cylinder
when the unit is not in use.
If the appliance is stored indoors the cylinder must be
disconnected and removed from the appliance.
Cylinders must be stored outdoors in a well-ventilated
area out of the reach of children.
, at
9
Operating Instructions
Lighting Instructions
CAUTIONS