Publicité
Les langues disponibles
Les langues disponibles
1. Release any built up moisture in moisture filter.
2. Turn off the compressor.
3. Release any leftover air by pressing down on your airbrush trigger (being careful of any excess paint) or unscrewing your airbrush
from the air hose.
CHANGING THE AIR INTAKE FILTER
The filter only needs to be changed if it's significantly dirty or dirty enough to cut air flow into the compressor. Inspect your air intake filter
once per week with heavy compressor use.
•
Use your finger to pull out the filter cover and air intake filter.
•
Remove the sponge-like air filter and replace with new air intake filter (Part #IS012 – 10 pack).
•
Push filter cover with new air intake filter back into place.
IS800 SPRINT JET - RELEASING BUILT-UP MOISTURE IN THE MOISTURE FILTER
•
Release moisture by turning the air bleed valve knob toward the "–" sign. This will open the bleed valve and drain the collected moisture.
•
Use a paper towel and press it against the air bleed valve at the bottom of the moisture filter.
•
For optimal performance, do not allow excess water build-up in the moisture filter.
IS850 SMART JET - RELEASING BUILT-UP MOISTURE IN THE MOISTURE FILTER
•
Use a paper towel and press it against the air bleed valve at the bottom of the moisture filter.
•
For optimal performance, do not allow excess water build-up in the moisture filter.
All manuals and user guides at all-guides.com
ENDING A SESSION
MAINTENANCE
7
Publicité
