Publicité
Les langues disponibles
Les langues disponibles
CAUTIONS:
• Always work in a well-ventilated area and away from flammable solvent vapors or wet surfaces.
• The air compressor can become very hot during prolonged use. Avoid running continuously without a break for more than 1 hour
at a time. Use caution when handling the compressor at this time.
• The motor is thermally protected and automatically shuts off the compressor when it becomes overheated. If this occurs turn the
compressor off and wait to restart until after it cools.
• DO NOT place the air compressor between you and your work area or directly under an area being sprayed. This could allow for
over spray from the airbrush to flow into the air intake of the compressor and damage the unit.
1. Attach regulator and moisture trap assembly to compressor output using winged adpater, tightening clockwise.
2. Screw the coiled air hose onto the compressor fitting located above the shut-off switch.
3.
Screw the other end of the coiled air hose onto the moisture filter's side facing small screw.
4.
Screw the large end of the straight air hose onto the moisture filter's front facing screw.
5. Screw the straight air hose onto the airbrush. If you're using a brand of airbrush other than Iwata, use the appropriate adapter.
6. Choose the appropriate international plug (IS 850 SA only).
7. Plug the unit into a grounded electrical wall outlet that meets all local government specifications. Use only a grounded extension cord
(minimum 16 AWG required).
8. Turn ON the unit by pressing the on/off switch. As the stored air depletes the unit will run to replenish the stored air.
9. Adjust the air pressure by turning the air pressure regulator. Turn knob toward "+" to increase pressure and toward "-" to decrease pressure.
Push down on the knob to lock it in place and pull up to adjust.
NOTE ON MOISTURE: Moisture will condense in the clear bowl of the moisture filter. To release this built-up moisture, use a paper towel and
press up on the moisture drain valve at the bottom of the moisture filter. How often you need to do this will vary depending on humidity.
All manuals and user guides at all-guides.com
IS850 SMART JET — GETTING STARTED
6
Publicité
