Safety information
This appliance is intended to be used exclusively for the storage
of wine.Before switching on the appliance for the rst time read
the following safety hints:
WARNING!
Before rst use
▶ Make sure there is no transport damage.
▶ Remove all packaging and keep out of children´s reach and dis-
pose them in an environmentally friendly manner.
▶ Wait at least two hours before installing the appliance in order to
▶ Handle the appliance always with at least two persons because
it is heavy.
Installation
▶ The appliance should be placed in a well-ventilated place.Ensure
a space of at least 10 cm above and around the appliance.
▶ WARNING: Keep ventilation openings, in the appliance enclo-
sure or in the built-in structure, clear of obstruction.
▶ Never place the appliance in a damp area or location where it
might be splashed with water.Clean and dry water splashes and
stains with a soft clean cloth.
▶ Do not install your wine cellar in any location not properly insulat-
ed or heated (e.g. garage etc). Your wine cellar was not designed
to operate in ambient temperature below 10 °C.
▶ Do not install the appliance in direct sunlight or in the near of
heat sources(e.g.stoves,heaters).
▶ Install and level the appliance in an area suitable for its size and
use.
▶ Make sure that the electrical information on the rating plate
agrees with the power supply.If it does not,contact an electri-
cian.
▶ The appliance is operated by a 220-240 VAC/50 Hz power sup-
to start,or damage to the temperature control or compressor,or
there may be an abnormal noise when operating.In such case,an
automatic regulator shall be mounted.
▶ Do not use multi-plug adapters and extension cables.
4
EN