Publicité
INSTALLATION
Oven burner
Remove the 2 screws from the flame guard
and remove the guard. This will now give you
access to the oven injector.
Remove the clips from the ignitor and the
thermocouple. Slide the ignitor and the ther-
mocouple out of their clap sockets.
Press down on the clip then lift up and slide
out the burner manifold.
Remove the injector with a 7mm spanner
and replace the injector with the ones from
the spare set, with corresponding diameters
suitable to the type of gas that is going to
be used, according to the information chart
(which is also supplied in the gas conversion
kit).
Grill burner
Unscrew the screw fixing the front cover of
the grill burner.
Gently pull down burner - be careful with
thermoccuple/spark plug holder.
After removing the rear cover of the burner,
you can reach the grill burner tube and grill
injector.
Remove the injector with a 7mm spanner
and replace the injector with the ones from
the spare set, with corresponding diameters
suitable to the type of gas that is going to be
used, according to the information chart.
Note : Le réglage terminé,
il est impératif de poser sur
l'appareil un autocollant qui
indique le type de gaz auquel
la cuisinière a été adaptée.
24
Publicité
