Hilti SL 2-22 Mode D'emploi page 25

2. Make sure that the contacts on the battery and the contacts on the
charger are clean and dry.
3. Use an approved charger to charge the battery. → page 18
5.2 Inserting the battery
WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery
and the contacts on the product are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.3 Removing the battery
1. Press the battery release button.
2. Remove the battery from the product.
5.4 Turning the lamp head
▶ Turn the lamp head to the desired position.
The lamp head can be turned in either direction along the axis. Do
not attempt to force the lamp head past the end stops.
5.5 Switching on / off
1. Turn the lamp head to the desired position. → page 21
2. Select a mode by repeatedly pressing the mode switch.
▶ Brightness 100 %
▶ Brightness 50 %
▶ Off
3. To switch off, repeatedly press the mode selector until the light source
of the cordless lamp goes out.
5.6 Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether
for possible damage.
▶ Do not secure a tool tether to the belt hook. Do not use a belt hook to lift
the product.
*2265886*
2265886 English 21