Broan Best IS170 Instructions D'installation page 13

HALOGEN BULBS
This range hood requires
bulbs (max 20W, 12V, TYPE MR16 bulb
shielded, GU 5.3 Base).
ALWAYS SWITCH OFF THE ELECTRICITY
SUPPLY BEFORE CARRYING OUT ANY
OPERATIONS ON THE APPLIANCE.
To change bulbs:
1. Loosen the ring nut by turning it
counterclockwise.
2. Pull the bulb downwards to remove - DO
NOT ROTATE. CAUTION: BULB MAY BE
HOT!
3. Replace with halogen bulb type max 20W,
12V, MR16 bulb shielded, GU 5.3 Base.
IN CASE THE NEW HALOGEN BULB DOES
NOT LIGHT UP ONCE IT IS ON, CALL FOR
SERVICE.
FUSE REPLACEMENT
SWITCH OFF THE ELECTRICITY SUPPLY.
To lift the lower flue.
Open the electrical box.
Replace with the same type of fuse (5x20mm,
5A, 125V).
four (4) halogen
- 13 -
BULB
RING NUT
ELECTRICAL
BOX
FUSE