LD Systems XEDAI Manuel D'utilisation page 9

Once the unit is online, click on the unit in the PROJECT
DEVICES list and select the SETTINGS menu on the right to go
directly to the settings menu and change the IP settings of the
unit. For more details about the complete unit configuration
with the QUESTRA software, please download the latest version
from the LD Systems website (www.ld-systems.com)
to your computer and read the user manual.
QUESTRA SOFTWARE
The Questra software not only enables comprehensive configuration of
compatible devices, such as IPA Series amplifiers, but also provides integration
capabilities for third-party remote control units and allows users to create their
own custom control panels that can be controlled via the Questra remote control
apps available for iOS, Android, Windows and MAC OS.
Please download the latest version of the QUESTRA software from the LD Systems
website (www.ld-systems.com) to your computer, check the system requirements
for the software and follow the software instructions to start configuring a unit.
DANTE CONTROLLER
TM
Setting up a Dante network is done with the help of the freely available
TM
software DANTE CONTROLLER. Download the software from the manufacturer's
TM
website www.audinate.com and install it on a computer. Connect the Ethernet
interface of the computer to the Dante network where the Dante interface of
TM TM
the XEDAI module is connected using a network cable (Cat. 5e or better) and run
the Dante Controller software. The software has automatic device detection.
TM
Signal routing is done by mouse click and the device and channel designations
can be edited individually by the user. IP address, MAC address and other
information about the devices in the Dante network can be displayed in the
TM
software.
When the configuration of the units in the Dante network is complete, the
TM
Dante Controller software can be closed and the computer disconnected from
TM
the network. The settings in the units on the network are retained.
9