LD Systems XEDAI Manuel D'utilisation page 8

FIRST STEPS
The XEDAI modules are delivered with a pre-configured static IP address
(192.168.0.192) as standard. To be able to recognise the unit with the Questra
software, please make sure that the IP settings of the computer on which the
Questra software is installed are configured in the same network range as the
XEDAI modules. See notes below.
• IP range : 192.168.0.X/24 (where X can be any value between 1 and 254, except
192 which is already used by default by the XEDAI modules)
• Network mask : 255.255.255.0
Once a device with a XEDAI module is connected to a network and switched on,
it will appear under the AVAILABLE DEVICES section in the ADD DEVICES field on
the left. Please note that multicast traffic must be enabled in the switch/router
for the device to be detected.
Drag and drop the device into the PROJECT DEVICES area to be able to configure
it. Then click the Offline button at the top of the screen and select Download
from Devices and connect to connect to the device.
8