LD Systems XEDAI Manuel D'utilisation page 6

CONNECTIONS, CONTROLS AND INDICATORS
1 ETHERNET
Ethernet interface with RJ45 socket for controlling the installation amplifier
via QUESTRA application software available free of charge.
DANTE
2
TM
Dante interface with RJ45 socket for connecting the IPA amplifiers to a Dante
TM
audio network (4 IN – 4 OUT).
STATUS
3
The status LED provides information about the internal integration between
the card and the main board in the IPA power amplifier (firmware compatibility,
internal communication problems):
• White flashing during start-up. The unit is loading the data for IPA.
• Permanently white: The network stack in the card is ready – The IP settings
have been configured properly.
• Permanent red – Firmware is not compatible with motherboard, problems
with network stack.
• White flashing (slow/fast) during IP reset procedure.
4 IP RESET
Long press activates the IP reset procedure. Initially, the status LED flashes
slowly in white and when the button is pressed for 5 seconds, the status LED
flashes quickly to indicate that the IP reset procedure will be carried out after
the button is released. The device will obtain the default IP address, which is
192.168.0.192 with a subnet mask of 255.255.255.0.
6
2 1
3
4
TM