GE MCP2024DXBB Instructions D'installation page 5

2 LAY COOKTOP UPSIDE DOWN
Place a towel or table cloth onto the counter top. Lay the
cooktop upside down onto the protected surface.
Table cloth
Figure 6
3 APPLY TAPE
A foam tape is provided to seal the cooktop edges to the
countertop.
Apply tape approximately 1/16" (1.5 mm) from the glass
edge to the underside of the cooktop glass. Use tape
around the entire glass perimeter. Cut off excess where
tape ends butt.
Burner box
Cooktop glass
Figure 7
Installation Instructions
Burner box
Foam tape
seal
4 INSERT COOKTOP
Insert the cooktop centered into the cutout opening. Make
sure the front edge of the counter top is parallel to the
cooktop. Make final check that all required clearances are
met.
Figure 8
5 CLAMP THE COOKTOP
Four clamp brackets are provided to clamp the cooktop to
the countertop. Tighten screws just enough to hold
brackets in place when cooktop is put into cutout. Tighten
screws securely.
Figure 9 (30"/36" models)
Figure 9b (24" model)
5