Télécharger Imprimer la page

BOMANN HTD 800 CB Mode D'emploi page 21

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 10
WARNING:
• Children must not play with the appliance.
• Cleaning and user maintenance must not be carried out by
children, unless they are supervised.
• Do not try to repair the appliance on your own. Always contact an
authorized technician. To avoid the exposure to danger, always
have faulty cable be replaced only by the manufacturer, by our
customer service or by qualified person and with a cable of the
same type.
• The nozzles become hot during operation!
• If the appliance is used in the bathroom, disconnect it from the
mains after use as nearby water presents a hazard. This also
applies if the appliance is switched off.
• Please ensure that the inlet grille remains free of fluff and hairs.
Danger of fire!
• As additional protection we recommend the installation of a fault
current protection device (FI/RCD) with a rated current of not more
than 30 mA in the wiring system of the bathroom. Please contact an
authorised electrician for advice.
• Please observe the instructions that we have included for you in the
chapter "Maintenance and care".
Commissioning
Unwind the mains cable completely. Fold out the handle.
Attach a nozzle if necessary.
You can dry single hair locks by concentrating the flow
of hot air with the hairdressing nozzle.
The diffuser is the ideal solution to dry curly hair without
losing volume.
In order to replace the attachment, first remove the old
attachment by pulling it off and then pushing on the new
one until it clicks into place.
Electrical Connection
Before inserting the plug into the socket. Make sure that
the mains voltage to be used matches that of the device.
You can find this information on the nameplate. Switch the
voltage from 110 V to 230 V using the voltage selector on
the bottom of the handle.
Connect the appliance to a properly installed earthed
socket.
21

Publicité

loading