Before plugging in the line cord, make sure that the
power switch is in the OFF (O) position.
6. Remove the line cord from the storage bin in the rear of the
unit.
7. Plug into a 115V/60Hz wall outlet.
8. Insert the nebulizer mouthpiece into the top of the
nebulizer.
NOTE: Before attempting to start a cold unit, let the unit reach room
temperature in a heated area.
Treatment Instructions
NOTE: For this procedure, refer to FIGURE 2.2 on page 20.
1. Press the power switch ON (-) to start the compressor.
Part No 1130204
SECTION 2—OPERATING INSTRUCTIONS
FIGURE 2.1 Adding Medication
WARNING
Eyedropper
Nebulizer Cup
19
Stratos
Pro
™