Chain Counter Setting Menu - MZ electronic EV-020 Instructions D'utilisation

Once the initialisation procedure is complete, the main page will appear.
Where:
STATUS: indicates the status of the instrument and any failure.
SPEED': indicates the chain speed during hoisting or lowering in meters per minute or feet per minute.
COUNT: indicates the measurement of the chain lowered (in metres or feet).
MONITORING: indicates the power supply voltage.
ICONS: this is the part of the display bearing the icons that indicate the hoisting or casting of the anchor
and any failure.
When the instrument is turned on for the first time, it will set up as programmed in the factory (see table).

Chain counter setting menu

Hold down the
to access the instrument setting menu. The
following page will appear on the display:
Use the (DOWN) and
move around the menu options.
Once you are positioned on the item to be modified press the
choice.
Use the (DOWN) or
Once one is positioned on the parameter press the
According to the type of parameter, using the
reduce/increase the value of the same or disable/enable the function.
EV-020
STATUS
SPEED'
COUNT
MONITORING
Parameter
Up Alarm
Auto Down
BackLight Time
Units of measurement
Chain Measure
Barbotin Circumference
Sensor type
Keyboard Beep
Language
Works Hours
Division factor
(ON) key for six seconds
(UP) keys to
(UP) keys to move from one parameter to another.
Stop
0.0 ft/m
0.0
ft
V=11.6
Default value
3.0 metres
Off
30 seconds
Metres/centimetres
0.0 metres
33 cm
unknown
Yes
Italian
0
1
Menu
M e a s u r e
A l a r m s & F u n c t i o n
S e t t i n g s
L a n g u a g e
S e n s o r C a l i b r a t i o n
Menu
L a n g u a g e
S e n s o r C a l i b r a t i o n
Te s t s
E x i t
(ON) key to enable modification.
(DOWN) and
20
English
ICONS
metres / minute
feet / minute
metres / feet
(ON) key to confirm your
(UP) keys it is possible to
Rev. 11 – 2014