MZ electronic EV-020 Instructions D'utilisation page 18

Warning
ALWAYS DISCONNECT THE BATTERY PRIOR TO INSTALLATION.
The chain counter must be positioned so that the display will be easy to read. It should not be
•
exposed to direct sunlight.
Secure the instrument in place with the bracket provided, tightening the two screws using a
•
cross screwdriver.
Drill on the dashboard one hole of 20.5 mm (~13/16") and 4 holes of 2.2 mm (~3/32") to fasten
•
the connector tap.
Put the gasket between the rear part
•
of tap and the dashboard.
The rear part must be protected from
•
contact with water or moisture.
For instructions on making electrical
•
connections, see the attached
diagram. The wires must have a
minimum cross section size of 1.5
mm².
Install a 3 A (ampere) fast safety
•
fuse on the + wire of the battery. Do
not use the voltage generated by the
engine battery set to provide power.
The instrument complies with EMC
•
standards (EN55022) and must be
positioned at a distance of:
30 cm (~1 Ft) from the compass;
−
50 cm (~1.5 Ft) from radio
−
EV-020 18
English
Rev. 11 – 2014