Publicité
Les langues disponibles
Les langues disponibles
Do not use electrical appliances inside the food storage compartments of
•
the appliance, unless they are of the type recommended by the
manufacturer.
Do not use water spray and steam to clean the appliance.
•
Clean the appliance with a moist soft cloth. Only use neutral detergents.
•
Do not use abrasive products, abrasive cleaning pads, solvents or metal
objects.
Do not store explosive substances such as aerosol cans with a flammable
•
propellant in this appliance.
If the supply cord is damaged, it must be replaced by the manufacturer, its
•
Authorised Service Centre or similarly qualified persons in order to avoid a
hazard.
Safety instructions
Installation
Warning! Only a qualified person must
install this appliance.
•
Remove all the packaging and the transit bolts.
•
Do not install or use a damaged appliance.
•
Follow the installation instruction supplied with the
appliance.
•
Always take care when moving the appliance as it is
heavy. Always use safety gloves and enclosed
footwear.
•
Make sure the air can circulate around the
appliance.
•
Wait at least 4 hours before connecting the
appliance to the power supply. This is to allow the
oil to flow back in the compressor.
•
Do not install the appliance close to radiators or
cookers, oven or hobs.
•
The rear of the appliance must stand against the
wall.
•
Do not install the appliance where there is direct
sunlight.
•
Do not install this appliance in areas that are too
humid or too colds, such as the construction
appendices, garages or wine cellars.
•
When you move the appliance, lift it by the front
edge to avoid scratching the floor.
Electrical connection
Warning! Risk of fire and electrical
shock.
•
The appliance must be earthed.
•
Make sure that the electrical information on the
rating plate agrees with the power supply. If not,
contact an electrician.
•
Always use a correctly installed shockproof socket.
•
Do not use multi-plug adapters and extension
cables.
•
Make sure not to cause damage to the electrical
components (e.g. mains plug, mains cable,
compressor). Contact the Authorised Service Centre
or an electrician to change the electrical
components.
•
The mains cable must stay below the level of the
mains plug.
•
Connect the mains plug to the mains socket only at
the end of the installation. Make sure that there is
access to the mains plug after the installation.
•
Do not pull the mains cable to disconnect the
appliance. Always pull the mains plug.
Use
Warning! Risk of injury, burns, electrical
shock or fire.
•
Do not change the specification of this appliance.
•
Do not put electrical appliances (e.g. ice cream
makers) in the appliance unless they are stated
applicable by the manufacturer.
•
Be careful not to cause damage to the refrigerant
circuit. It contains isobutane (R600a), a natural gas
with a high level of environmental compatibility. This
gas is flammable.
•
If damage occurs to the refrigerant circuit, make
sure that there are no flames and sources of ignition
in the room. Ventilate the room.
13
Publicité
