Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
Recharge only with the charger
WARNING
specified for the battery. For spe-
cific charging instructions, read the operator's
manual supplied with your charger and battery.
Removing/Inserting the Battery
To remove the battery, push in the release buttons
and pull the battery pack away from the tool.
Always remove battery pack before
WARNING
changing or removing accessories.
To insert the battery, slide the pack into the body
of the tool. Make sure it latches securely into place.
Only use accessories specifically
WARNING
recommended for this tool.
Others may be hazardous.
Attaching, Removing, and Adjusting the
Shear Head
1. Remove the battery pack.
2. Place the shear head on the gear case collar of
the tool.
3. Align the shear head and tool to the desired angle.
Move the left blade forward or backward to adjust
the curl of waste material.
4. Tighten the three cap screws in the order indicated
(A, B, C), with the wrench provided. Be sure the
screws are securely tightened (40-50 in-lbs.)
before using the tool.
A
B
5. To remove, loosen the three cap screws and firmly
pull the shear head forward, twisting slightly.
Applying Lubricant
When necessary, apply a
s m a l l
a m o u n t
MILWAUKEE type "E"
grease to the flats in the
U-shaped area of the
center blade.
C
Left blade
o f
Center blade
WARNING
to comply with ANSI Z87.1.
Always remove battery pack before changing
or removing accessories. Only use accessories
specifically recommended for this tool. Others
may be hazardous.
Rotating the Shear Head
Pull back the head rotation button and rotate the
head to a comfortable cutting position. Make sure
the head snaps into the nearest detent before use.
Starting, Stopping, and Controlling Speed
1. To start the tool, pull the trigger.
2. To vary the cutting speed, increase or decrease
pressure on the trigger. The further the trigger is
pulled, the greater the speed.
3. To stop the tool, release the trigger.
Always allow the motor to come to a complete stop
before locking the trigger. Always lock the trigger or
remove the battery pack before performing mainte-
nance, changing accessories, storing the tool and
any time the tool is not in use.
To lock the trigger, push the trigger lock from the
LOCK side of the tool. To unlock, push the trigger
lock to the
Preparing the Material
Always lubricate the material to be cut. Use standard
machine oil on steel and mineral spirits for aluminum.
When cutting, hold the tool so that the blades are in
firm contact with the material for the fastest cutting.
Apply even pressure. Too much pressure will tend
to jam the tool or cause a rough cut.
Flats
4
OPERATION
To reduce the risk of injury, always
wear proper eye protection marked
Locking the Trigger
UNLOCK side of the tool.
Cutting
Publicité
