Guardian A5 Manuel D'instructions page 5

Step 1

Using a concrete drill bit, drill a 3/4 in (19 mm)
hole into the base material to a depth of at
least 3 1/2 in (89 mm). Ensure hole is uniform
in both shape and diameter with no wide or
narrow sections.
Step 2

Blow the hole clean of dust, debris, and other
foreign material with compressed air.
Step 3

To install the A5 Concrete Expansion Anchor,
place thumb inside the connection loop and
first two fingers around trigger. Squeeze thumb
and fingers together until the trigger and
spring fully compress.
Step 4

Insert A5 Concrete
a minimum 3 in (76 mm) deep into installation
hole and release the trigger. The stop sleeve
must always be at least partially inserted into
installation hole. NEVER force A5 Concrete
Expansion Anchor into the hole.
Step 5

Seat A5 Concrete Expansion Anchor by
pulling sharply on the connection loop until
it securely fixes in place. Ensure device
maintains position and minimum 3 in (76 mm)
installation depth after seating.
Step 6

Attach compatible PFAS to A5 Concrete
Expansion Anchor connection loop. Maximum
one (1) connection permitted at any time.
Step 7

To remove A5 Concrete Expansion Anchor,
compress the trigger and spring, and pull out
of installation hole.
Step 8

A5 Concrete Expansion Anchor may be
removed and reinstalled at multiple locations,
provided all installation requirements are met.
Always inspect hole prior to installation.
Expansion Anchor
Bottom of stop sleeve
must be inserted at
least partially below
concrete surface.
Min. insertion
depth 3 in
(76 mm)
Loading Directions
 WARNING! Never load Concrete Expansion
Anchor at an angle grater than 90 degrees.
 WARNING! Never load Concrete Expansion
Anchor over the edge of the substrate.
OK
NO
5
Concrete
Surface
min. hole depth
3.5 in
(89 mm)
OK
OK
NO