HOLZMANN MASCHINEN HOB305PROSMW2 230V Mode D'emploi page 42

16.6.1 Planing small workpieces
16.6.2 Planing with tilted planer fence
16.6.3 Planing short workpieces
16.6.4 Planing the workpiece with small cross section
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
• Press the workpiece against the planer table with one hand.
• Push the workpiece slowly and evenly over the shaft with
the second hand.
• After finishing the operation switch off the machine.
• Wait until the shaft has come to a standstill before
proceeding with any further work!
• Lower the planer knife cover (C) so that the planing shaft is
covered.
• Move the planer knife cover to the workpiece and fix it with
a distance of approx. 5mm.
• When planing, place the workpiece with the small side on
the planer table and press with one hand against the planer
fence and planer table.
• Push the workpiece slowly and evenly over the shaft with
the second hand.
• Lower the planer knife cover so that the planing shaft is
covered.
• Move the planer knife cover to the workpiece and fix it with
a distance of approx. 5mm.
• When planing, place the workpiece with the small side on
the planer table and press with one hand against the planer
fence and planer table.
• Push the workpiece slowly and evenly over the shaft with
the second hand.
• When planing short workpieces, a sliding wood or similar
device should be used!
• Adjust planer fence and blade guard to the size of the
sliding wood.
• Place the workpiece on top and push it slowly and evenly
over the shaft using the sliding wood.
• After use, the sliding wood must be reattached on his place
on the side of the machine.
• When planing workpieces with a small cross-section, an
additional wood angle must be mounted!
• Fasten the wood angle to the planer fence as shown using
lever clamps.
• When planing, place the workpiece on the planer table and
press it against the additional wood angle and planer table.
• Place the workpiece on top and push it slowly and evenly
over the shaft using the sliding wood.
HOB305PROSMW2_230V | HOB305PROSMW2_400V
OPERATION
42