HOLZMANN MASCHINEN HOB305PROSMW2 230V Mode D'emploi page 40

The alignment of the planer fence at right angles should be checked again
before initial operation and readjusted if necessary to achieve an exact
planing result.
16.4 Handling
16.4.1 Switch the machine on and off
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
4. Setting arm and planer knife cover
Height
• Set the desired height with the adjusting screw (5)
Planer knife cover
• Loosen the clamping screw (6)
• The planer knife cover can be moved and adapted
• Relock the clamping screw (6) when the desired
5. Setting planer fence
Angle:
• Loosen clamping levers (7)
• Set planer fence to desired angle position
• Relock clamping levers (7) when the desired angle
Rear protective cover (11):
• Loosen screws (10) and set the rear protective cover
• Retighten the screws
Moving left / right
• Lossen clamping levers (8)
• Set planer fence to desired position
• Relock clamping levers (8)
Moving forward / backward
• Lossen clamping screws (9)
• Set planer fence to desired position
• Relock clamping screws (8)
• The angle is measured with a protractor (13). This is placed on the planer
table and applied to the planer fence.
• If it is not possible to place the protractor completely against the planer
fence, the planer fence is not set exactly at right angles and an
adjustment is necessary.
• The angle is adjusted with the screw (12).
Switch on
Push green ON-button (I)
Switch off
Push red OFF-button (0) or in emergency situations the
emergency-stop button
CAUTION: The emergency stop button can only be unlocked
after the emergency situation has been eliminated.
to the size of the workpiece
position is reached.
position is reached
as near as possible to the planer fence
HOB305PROSMW2_230V | HOB305PROSMW2_400V
OPERATION
40