HOLZMANN MASCHINEN HOB305PROSMW2 230V Mode D'emploi page 41

16.4.2 Activating/Deactivating the thicknesser feed rate
16.5 Dust collection plug
Do not operate the machine without the dust collection system connected to it and switched on.
The dimensions of the dust collection plug can be found in the technical data.
16.6 Planing
The unused part of the planing shaft for machining the workpiece must be covered by
the covers (planer knife cover, guidance planer fence). Never touch the edges of the
workpiece with your fingers, but always leave both hands on the workpiece with your
fingers when planing. If the workpiece is short and narrow, use the sliding wood.
Only plane workpieces that rest firmly on the machine and that can be guided safely!
working direction
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Activate feed:
Swivel the lever for thicknesser feeder (1) upwards.
Feed is activated
Deactivated feed:
Swivel the lever for thicknesser feeder (1)
downwards. Feed is deactivated.
Planer:
The extraction connection (1) is under the planer
tables (exit planer table)
NOTE:
see chapter Assembling the machine => Assembly
dust collector hood
Thicknesser:
After the conversion to thicknessing, fold down the
dust colletor hood (2).
WARNING
• Fix the planer fence (1) in the
desired working position.
• Set the desired planing thickness
on the adjusting screw (3).
• Adjust the planer knife cover (2) so
that the distance between the
cover and the workpiece is approx.
5mm.
• Set rear protective cover to the
planer fence
• Start machine
HOB305PROSMW2_230V | HOB305PROSMW2_400V
OPERATION
41