Fulgor Milano FCLCSO 4510 TEM Instructions Pour L'installation Et L'utilisation page 60

17 - Oven Care and Cleaning
EN
Oven Clean
This function performs a cleaning cycle by injecting steam into
the cavity for 15 minutes. At the end of the cycle, any crusting
that may have formed due to high-temperature cooking inside
the oven cavity, will be softened and become much easier to
remove.
ATTENTION
Once the functions have been completed, a circuit discharge
request will be sent (see WATER DISCHARGE paragraph).
Circuit Clean
This function performs a cleaning cycle of the circuit, to keep it
clean and efficient over time.
ATTENTION
Once the functions have been completed, a circuit discharge
request will be sent (see WATER DISCHARGE paragraph).
This oven is one of its kind insofar as it does not
require any descalers to keep the steam generation
system running efficiently.
Circuit discharge
At the end of any steam function, when the oven is turned off
using the key a circuit discharge is requested.
The following message will appear on the display: NEED TO
DISCHARGE / OPEN THE DOOR.
Open the door, watching out for the hot steam that will be
released. A new message will appear on the display with an
animated icon, requesting the user to extract the container until
the symbol indicated on the same. Press the key
steam circuit discharge.
24
At the end of the procedure, the message DISCHARGE
ENDED / REMOVE AND EMPTY THE TANK will appear on
the display, confirming that the discharge was successful. If you
do not wish to immediately repeat a new steam cooking cycle,
it is recommended to empty the container and replace it in its
housing, then close the door.
The oven is now ready for a new cooking cycle.
to start the