Publicité
Les langues disponibles
Les langues disponibles
O
PERATING THE UNIT
Please note:
If the suction function is defective, the device must no longer be used!
J. Thermal cutoff of the suction turbine
If the suction turbine is not cooled adequately and the air temperature in the suction turbine housing exceeds
80°C, the suction turbine and the handpiece are switched off. On the display, the error message "OVERHEAT"
is shown:
•
After the temperature in the suction turbine housing has dropped by approx. 10 - 15 °C, this reading
disappears. The device is then in the standby mode.
Possible reasons for an overheating of the suction turbine
- Blockage in the suction hose or in the handpiece
- Overfilled filter bag
- Insufficient air circulation at the rear of the device
DE
- Grinding dust in the area of the turbine due to a burst dust bag or by using the device without a dust bag.
Attention:
If the reasons mentioned above can be ruled out, we recommend you to immediately send your device back
EN
for servicing!
K. Saving speed values / memory function
FR
A speed chosen by pressing the button (L) or (N), can be saved by pressing any memory button (P) for at
least 3 seconds. For example, on M1, a low speed for large milling cutters, on M2, an average speed for
medium-sized milling cutters, and on M3, a higher speed for small milling cutters.
The chosen suction capacity and the milling cutter's direction of rotation are also saved. The memory setting
IT
chosen is shown in the middle of the display (J).
ES
NL
The following memory values have already been factory-set:
M1
=
RU
M2
=
M3
=
PL
These settings can be changed as described above. Saving a chosen speed is confirmed by the display "Save":
SE
FI
(8,000 rpm; suction capacity 4 bars = 30%)
(15,000 rpm; suction capacity 8 bars = 60%)
(20,000 rpm; suction capacity 11 bars = 85%)
Publicité
