Velleman VTSSC30N Mode D'emploi page 7

7. Cleaning and Maintenance
•
Soldering tips can be replaced simply by unscrewing the barrel nut assembly. Turn off the station and
allow it to cool down first. Damage to the soldering station may occur if the system is left on and the
removed tip has not been replaced.
•
After removing the tip, you should blow out any oxide dust that may have formed in the tip
receptacle. Be careful not to get dust in your eyes. Replace the tip and tighten the screw. Pliers can
be used to avoid contact with hot surfaces BUT SHOULD BE USED WITH CAUTION because over-
tightening may cause damage to the element or fuse the tip to the element.
•
The outer cover of the iron and station may be cleaned with a damp cloth using small amounts of
liquid detergent. Never submerse the unit in liquid or allow any liquid to enter the case of the station.
Never use any solvent to clean the case.
•
If the iron or station should become faulty or, for some reason does not operate normally, the
system should be returned to the service department of your authorized dealer or service agent.
8. Technical Specifications
max. heater power for soldering iron ................................................................ 48 W
power supply ............................................................................. 220-240 V~, 50 Hz
temperature range ................................................................................ 160-480 °C
operating voltage ............................................................................................ 24 V
weight ....................................................................................................... 1.75 kg
dimensions ............................................. 120 x 170 x 90 mm (without stand and iron)
replacement bits
1.0 mm ............................................................................................... BITC10N2
3.0 mm ............................................................................................... BITC10N3
2.0 mm ............................................................................................... BITC10N4
replacement soldering iron .................................................................. VTSSC10N/SP
Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulting from (incorrect) use of this device. For more info
concerning this product and the latest version of this manual, please visit our website
www.velleman.eu. The information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part
of this manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise
without the prior written consent of the copyright holder.
V. 06 – 24/02/2021
VTSSC30N
7 ©Velleman nv