Genesis GHD1260B Manuel D'utilisation page 6

Never hold the workpiece in your hand, lap or against other parts of the
•
body
when drilling. Contact with the drill bit can cause injury.
Always position the cord away from the rotating bit and DO NOT wrap the
•
cord around your arm or wrist
control of the drill and become entrapped by the cord, causing personal injury.
When using the drill, DO NOT position yourself between the tool and a wall
•
or post
. If the bit jams or becomes bound in the work piece, the sudden reaction torque of the tool could
crush your hand, arm or leg against a stationary object.
If the bit jams or binds in the work
•
injury. unplug the drill from the power source and then remove the drill bit from the work. Do not attempt to
free the jammed drill bit by repeatedly starting and stopping the drill motor; this action could result in injury.
Do not use dull or damaged bits and accessories
•
to bind in the work piece.
Do not use bits larger then those recommended
•
loss of tool control and personal injury. Large bits may also overload the drill, causing motor and gear
damage.
When removing the drill bit from the tool, avoid contact with skin
•
sufficient time for the bit to cool down or use proper protective gloves to handle the bit or accessory. Drill bits
and accessories may be hot after prolonged use.
Wear cushioned gloves and take frequent rest breaks
•
considerable vibration when in operation which may be harmful to your hands and arms.
Use only percussion-type carbide tipped bits for hammer drilling
•
attempt cutting reinforcing rod with percussion-type bits.
Check the tool and remove any chuck keys or adjusting wrenches before
•
switching the tool "ON"
causing an injury.
WARNING:
instructions before using this equipment. Failure to follow all instructions listed below
may result in electric shock, fire and/or serious personal injury.
SAVE THESE INSTRUCTIONS
1/2" Hammer Drill
Operator's Manual
. If the cord is caught by the rotating bit or chuck you may lose
. Keys and wrenches can fly off at high speed striking you or a bystander,
Read and understand all warnings, cautions and operating
, immediately release the switch trigger to prevent personal
. Dull or damaged bits are more likely
. They are more likely to jam, causing
GHD1260B
. Allow
. Hammer drills can generate
and do not