Brandt BFD7611SW Manuel D'instruction page 41

 Wait until the freezer has reached the recommended temperature before putting the food back
in it.
Refreezing a thawed product encourages the spread of bacteria. This may become a health hazard
if the bacteria that spreads are pathogens, as these may cause more or less serious food poisoning
depending on the type of bacteria involved. If in doubt, cook the food involved.
Troubleshooting
Warning! If there is any anomaly, unplug your appliance. Only a qualified electrician
or competent person may carry out troubleshooting.
If there is any anomaly during operation, check the following points before calling our approved after
sales service or a qualified professional.
Problem
Appliance does
not work.
Appliance
freezes or
cools too
much.
Food is not
frozen enough.
Heavy build-up
of frost on the
door seal.
Water on the
floor.
Appliance
surfaces are
hot when in
use.
Unusual noises
Possible cause
The temperature knob is set to "0"
or "Off".
The power cord is not plugged in
or is loose.
Fuse has blown or is defective.
Outlet is defective.
Temperature is set too cold
Temperature is not properly set.
Door was open for an extended
period.
A large quantity of warm food was
placed in the appliance within the
last 24 hours.
The appliance is near a heat
source.
The door seal is not sealing.
Water drain hole is blocked.
This is normal. Heat exchanger
parts are located in the sidewalls.
The appliance is not level.
The appliance is touching the wall
or other objects.
A component, e.g. a pipe, on the
rear of the appliance is touching
another part of the appliance or
the wall.
Solution
Set the knob to a different position to switch
the appliance on.
Connect the power cord.
Check fuse, replace if necessary.
Electrical malfunctions need to be repaired
by an electrician.
Turn the thermostat to a warmer setting
temporarily.
Please refer to the section on
setting the temperature.
Only open the door when necessary.
Turn the thermostat to a colder setting
temporarily.
Please refer to the installation location
section
Carefully warm the leaking sections of the
door seal with a hair dryer (on a cool
setting). At the same time, handle the
heated door seal with your hands to ensure
that the appliance seals.
Please refer to the "Care and cleaning"
section.
Wear gloves when touching the sidewalls if
necessary.
Readjust the feet.
Move the appliance slightly.
If necessary, carefully bend the component
out of the way.