EUROM EK3000 Round Manuel D'utilisation page 28

Control panel
The control panel consists of two dials:

The mode selector dial with 4 positions is
located on the left:
- O or off
- fan and 1000W power
- fan and 2000W power
- fan and 3000W power

The continuously adjustable thermostat dial is
located on the right.
Location and Connection

Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact your
vendor for inspection or replacement.

Select a suitable location for the device taking into account all the aforementioned
warnings in this manual.

Make sure the heater is switched off (switch to O position), then plug into a correctly
functioning, properly grounded socket.
Set-up and Operation

If the heater is being used for the first time (or if you want to reset the desired
temperature), turn the thermostat dial to the maximum position (clockwise as far as it
goes).

With the mode selector dial, adjust the heater to suit your preferences: fan only, low
power or high power.

Once the temperature in the area being heated has reached the right level, slowly turn
the thermostat dial anticlockwise until you hear a soft click; leave the dial in that
position. The heater will automatically maintain the temperature at this level. It does
this by switching the heating elements off and on when the temperature rises or falls
too much.

Note! After the thermostat has switched the heating elements off, the fan will keep
turning. This means that the air is constantly moved, allowing the heater to accurately
detect if the area is cooling down.

The thermostat dial is continuously adjustable. A higher temperature is set by turning it
clockwise; a lower temperature by turning it anticlockwise.
Aftercooling
The heater is supplied with an aftercooling system. When switching the heater off, turn
the control knob to "off". O. The heater will first ventilate in order to cool down internally.
This can take several minutes, depending on the ambient temperature. Then the heater
28