Braun 5693 Mode D'emploi page 10

high high
low low
empty empty
Series Series
Ser ies Ser ies
r e l e as e r e l e as e
Series 7 Series 7
r e l e as e r e l e as e
click! click!
Series 7 Series 7
r e l e as e r e l e as e
Series 7 Series 7
r e l e as e r e l e as e
Series 7 Series 7
r e l e as e r e l e as e
r e l e as e r e l e as e
10
Cleaning
Automatic cleaning
After each shave, return the shaver to the
Clean&Renew station and proceed as described
above in the section «Before shaving».
All charging and cleaning needs are then
automatically taken care of. With daily use, a
cleaning cartridge should be suffi cient for about
30 cleaning cycles.
The hygienic cleaning cartridge contains alcohol,
which once opened will naturally evaporate
slowly into the surrounding air. Each cartridge,
if not used daily, should be replaced after
approximately 8 weeks.
The cleaning cartridge also contains lubricates,
which may leave residual marks on the outer foil
frame after cleaning. However, these marks can
be removed easily by wiping gently with a cloth
or soft tissue paper.
Manual cleaning
The hand-held unit shall be detached from the
power supply cord before cleaning. The shaver
shall not be used until it has dried.
Rinsing the shaver head under running water
is an alternative way to keep the shaver clean,
especially when travelling:
• Switch the shaver on (cordless) and rinse the
shaver head under hot running water. You may
use liquid soap without abrasive substances.
Rinse off all foam and let the shaver run for a
few more seconds.
• Next, switch off
release button
8
cassette and let it dry.
• If you regularly clean the shaver under
water, then once a week apply a drop of
light machine oil on top of the foil and cutter
cassette.
Alternatively, you may clean the shaver using the
brush provided:
w
• Switch off the shaver. Remove the foil
and cutter cassette
surface. Using the brush, clean the inner area
of the pivoting head. However, do not clean the
cassette with the brush as this may damage it.
w
the shaver, press the
9
to remove the foil and cutter
8
and tap it out on a fl at