Publicité
Les langues disponibles
Les langues disponibles
5. OPERATING PROCEDURES
Check the oil level before each operations as outlined on page 9. Never change the accelerator
position which is set at the factory.
5.1. STARTING THE ENGINE
1.
Turn the engine switch to the position « I » (ON). Fig.
2.
Open the fuel cock. Fig.
3.
Pull the choke knob to close if the engine is cold. Fig.
[RECOIL STARTER MODEL] Fig.
•
Pull the starter handle slowly until resistance is felt. This is the «compression» point. Return the
handle to its original position and then pull swiftly.
If the engine fails to start after several attempts, repeat above procedures with choke knob returned
to open.
•
Do not fully pull out the rope.
•
Après le démarrage du moteur, la corde du lanceur doit retrouver sa position initiale. Pour cela
accompagner la poignée jusqu'au lanceur.
•
•
After the engine started, return the choke knob gradually to "OPEN" position.
Warm up the engine without a load for a few minutes.
[ELECTRICAL STARTER MODEL]
•
Insert the key inside the switch key and turn it to the '' I '' position. Then turn it right (START) in order
to start the engine. Fig.
•
When the engine started, turn the choke knob slowly to make the engine run and keep it to the full
normal position. Do no open it quickly when the engine is cold or the outside temperature is cold,
because the engine might stop. Let the engine warm for few minutes without load. Fig.
5
2
6
1
6
2
5
1
5
3
EN
FR
ES
IT
RO
6
3
11
Publicité
