Safety At Work - IGM FKP400 Mode D'emploi

• Always unplug the drilling machine when exchanging the dowel bit or setting the drilling machine.
• Don't touch the rotating parts when boring.
• Use hearing protectors.
• Always use a dust mask or a respirator.
• Don't wear loose clothing. Ensure that you have tucked your sleeves and that you don't wear any tie.
• Before switching the router on, ensure that the dowel bit is well tightened and the stop ring is secured.
• Prevent unwanted switching of the drilling machine: ensure that the switch of the drilling machine isn't
locked up in position "on" before plugging-in.
• Wait until the dowel bit is completely stopped before starting any setting of the drilling machine.
FKP400 – FKP656 SPARE PARTS LIST
Pos. # Description
Boring jig FKP400 corps
1
Boring jig FKP656 corps
2 Tightening flange complete
3 Edge stop D10x10
4 Centering pin D8
5 Screw M4x16
6 Screws M8x45
7* Press screw composition
*
not included in basis pack
Pos. # Description
Corps FKP101 with bearing
1
Corps FKP102 with bearing
Shaft FKP101
2
Shaft FKP102
3 Stop ring
4 Spring
5 Setting screw M4x4
6 Setting screw M4x5
7 Imbus key 2
8 Centering pin d5
9 Centering pin d7
_______________________________________________________________________
This document is for your personal use only. All usage and reproduction is forbidden without prior written permission from IGM Bohemia s.r.o.

SAFETY AT WORK

FKP101-102 Spare parts list
w w w . i g m t o o l s . c o m
IGM Bohemia s.r.o.
Hlavni 201 - CZ 25267 Tuchoměřice - PRAHA-ZÁPAD – Czech Republic - E.U.
Tel.: +420 220 950 910 – Fax: +420 220 950 911 – export@igmtools.com
© 2005 IGM Bohemia s.r.o.
- EN 5 -
FKP400 , 656 Operating instructions
v.2
Pieces in
Code
basis pack
1
1
2-3
2 FD3001-03
1 FKP9-18
FS200-154
2
4-6 FS200-155
1
v.1
Pieces
1 FKP101-10
1 FKP102-10
1 FKP101-2
1 FKP102-2
1 FKP101-3
1 FKP101-5
2 FS200 153
1 FS200 115
1 FS800 002
1 FKP9-15
1 FKP9-17
FKP4-1
FKP6-1
FKP200
FKP6-5
Code