IGM FKP400 Mode D'emploi page 6

FKP400 , 656 Operating instructions
CONFIRMATE joints producing
Dividing up of the cupboard elements is represented in the figure (fig. 9).
- Always before boring check whether the inner part of the jig is perfectly touching the workpiece.
-Always adjust the workpiece from the front side on and when boring hole into the side the tightening
flanges must be oriented to the reverse of the workpiece, never contrariwise!! Thus you ensure a
0,8 mm facet.
-Check the boring depth before boring.
-If the bored hole isn't clean the dowel bit must be grinded.
Boring holes into the side
Use the boring bush FKP102 with a dowel bit for blind holes with 5mm diameter. For boring depth range see
figure (fig. 3 & 8), for boring depth setting see above Dowel joint producing. Tighten a metal stop into the
hole at the jig edge. Place the FKP on the workpiece so that the edge stop is touching the front side of the
workpiece and the tightening flanges are oriented to the reverse of the workpiece. (fig. 10).
Ensure that the stop is touching the front side of the board and the inner parts of the jig are abutting on the
workpiece. Tighten the FKP by the tightening flanges. Tighten the screws by hand with optimal power – for
sufficient tightening no excessive power is needed. Set the boring depth of the boring bush. Put the boring
bush with respective dowel bit into the holes and bore confirmate holes (fig. 10). Bore rather deep holes on
multiple pass, so that the cuttings can be well evacuated. Keep the right revolutions direction - dowel bits are
delivered in right-handed construction.
Boring holes into the surface
Use the boring bush FKP101 with a dowel bit for 7 mm diameter through holes! Tighten a metal stop
into the hole at the jig edge. Place the FKP on the workpiece so that the edge stop is touching the front side
of the workpiece and the surface A of the jig is oriented to the reverse of the workpiece. (fig. 11).
Ensure that the stop is touching the front side of the board and the inner parts of the jig are abutting on the
workpiece. Tighten the FKP by the tightening flanges. Set the boring depth of the boring bush. Put the boring
bush with respective dowel bit into the holes and bore confirmate holes (fig. 11). Bore rather deep holes on
multiple pass so that the cuttings can be well evacuated. Keep the right revolutions direction - dowel bits are
delivered in right-handed construction.
Producing of longer joint than the jig
The working procedure is represented in the figure (fig. 12) .
The edge stop removed, the boring jig can be shifted along the workpiece side. To hold the last hole and
keep the 32 mm spacing, use centering pins, delivered with the basis package of boring bush FKP102. To
hold the position when boring into side, use the 5 mm diameter centering pin, when boring into surface, use
the 7 mm diameter centering pin. The procedure is the same as while boring with the edge stop, the jig
position on the workpiece is ensured by the centering pin.
WARNING!!!
While boring, press the boring bush to the jig to keep the perpendicularity. You can support the boring bush
with the other hand. Always keep the drilling machine perpendicular so that the boring bush is touching FK
with its entire surface. It is better to bore holes one multiple pass. Always follow the safety instructions
for work with the drilling machine!
- EN 4 -