IGM FKP400 Mode D'emploi page 5

FKP400 , 656 Operating instructions
ANGULAR JOINT PRODUCING
Dividing up of the cupboard elements is represented in the figure (fig. 4).
-Always before boring check whether the inner part of the jig is perfectly touching the workpiece.
-Always adjust the workpiece from the front side on and when boring hole into the side the tightening
flanges must be oriented to the reverse of the workpiece, never contrariwise!! Thus you ensure a
0,8 mm facet.
-Check the boring depth before boring.
-If the bored hole isn't clean the dowel bit must be grinded.
Boring holes into the side
Tighten a metal stop into the hole at the jig edge. Place the FKP on the workpiece so that the edge stop is
touching the front side of the workpiece and the tightening flanges are oriented to the reverse of the
workpiece. (fig. 5).
Ensure that the stop is touching the front side of the board and the inner parts of the jig are abutting on the
workpiece. Tighten the FKP by the tightening flanges. Tighten the screw by hand with optimal power – for
sufficient tightening no excessive power is needed. Set the boring depth of the boring bush. Put the boring
bush with respective dowel bit into the holes and bore dowel holes (fig. 5). Bore rather deep holes on
multiple pass, so that the cuttings can be well evacuated. Keep the right revolutions direction - dowel bits are
delivered in right-handed construction.
Boring holes into the surface
Tighten a metal stop into the hole at the jig edge. Place the FKP on the workpiece so that the edge stop is
touching the front side of the workpiece and the surface A of the jig is oriented to the reverse of the
workpiece. (fig. 6).
Ensure that the stop is touching the front side of the board and the inner parts of the jig are abutting on the
workpiece. Tighten the FKP by the tightening flanges. Tighten the screw by hand with optimal power – for
sufficient tightening no excessive power is needed. Set the boring depth of the boring bush. Put the boring
bush with respective dowel bit into the holes and bore dowel holes (fig. 6). Bore rather deep holes on
multiple pass, so that the cuttings can be well evacuated. Keep the right revolutions direction - dowel bits are
delivered in right-handed construction.
Producing of longer joint than the jig
The working procedure is represented in the figure (fig. 7) .
The edge stop removed, the boring jig can be shifted along the workpiece side. To hold the last hole and
keep the 32 mm spacing, use a centering pin. The boring jig is delivered with a centering pin for 8 mm
dowel diameter. The procedure is the same as when boring with the edge stop, the jig position on the
workpiece is ensured by the centering pin.
WARNING!!!
While boring, press the boring bush to the jig to keep the perpendicularity. You can support the boring bush
with the other hand. Always keep the drilling machine perpendicular so that the boring bush is touching FK
with its entire surface. It is better to bore holes one multiple pass. Always follow the safety instructions
for work with the drilling machine!
- EN 3 -