Philips TrueLine SP530P Manuel D'installation page 5

Cover remover (ZZS400 OCR)
Replace 9a, b, c,
asymmetric
!
LightEngine
(SP534P)
9a
!
Given the choices made in this unique lighting concept, there are a few instructions regarding the maintenance.
• Prevent water from entering on or in the luminaire at installation and during use of the luminaire
• During installation or maintaining the luminaire please use gloves to avoid spots on the cover.
• Do not clean with a dry cloth as it will cause the product to attract dust. Dirty spots can be removed:
Only dust: use a damped cloth (no dripping water),
preferably anti-static.
Fingerprints etc: use a damped cloth (no dripping water) with a cleaner
approriate for polycarbonate/PMMA plastics
• Do not touch electronic components as they are ESD sensitive.
• Do not stare into LED beam.
• Luminaire should not be used for illumination during building activities
due to dust accumulation inside the luminaire.
Inrush current
I max
max/2
!
LightEngine
1 mm
9b
I mains (A)
I nom.
Time (us)
Tref
LightEngine LightEngine
2 mm 2 mm
9c
9d
5/16
PoE
Condition Philips to specify to
the customers (instruction):
> to use UTP (Unshielded Twisted
Pair) CAT5E or CAT6 cable.
1 mm
> the maximum length of the cable
to be 20 meters.
Apply a minimum radius of the
Ethernet cable of 4x the cable
diameter.
POE types to be used with these POE
compatible power sources:
Cisco 3560X-24U-S
Cisco Catalyst 3850 24 Port UPOE IP Base
Phihong MidSpan injector POE90U-1BT
Huawei S5720 Series S5720-16X-PWH-LI-AC
Cisco CDB-8U
The light source of this luminaire is not
replaceable; when the light source reaches its end
of life the whole luminaire shall be replaced
LASER RADIATION
AVOID DIRECT EYE EXPOSURE
CLASS 2M LASER PRODUCT
210J/M
wg PN-EN 60825-1 -2005
2
/10S 443.533.552nm