Makita DCU603 Manuel D'instruction page 23

Adjusting the width of the carrier
NOTICE:
Make sure that the side rails and front
rail are fixed securely after tightening the thumb
nuts.
Loosen 6 thumb nuts, and then slide the side rails and
front rail. Tighten the thumb nuts to fix the side rails and
front rail.
Fig.43
► 1. Thumb nut 2. Rail
CAUTION:
Do not slide the rails beyond the
limit mark.
Fig.44
Adjusting the handle height
NOTICE:
same height.
The handle height can be adjusted in 7 levels. To adjust
the handle height, loosen 2 knobs, then adjust the handle
height by aligning the hole on the handle with the protru-
sion on the rear frame, and then tighten 2 knobs securely.
Adjust the height of the other handle in the same way.
1
Fig.45
► 1. Knob
2
Rear wheel lock
You can fix the direction of the rear wheels using the rear wheel lock.
1.
Slightly move the machine forward so that the rear
wheels face the direction shown in the figure.
Fig.46
► 1. Rear wheel
2. Rotate the rear wheel lock toward the rear.
Fig.47
► 1. Rear wheel lock
23 ENGLISH
Fix the left and right handles at the
1
1
1