Makita DCU603 Manuel D'instruction page 16

Installing or removing the flat
bucket
Optional accessory
Installing the flat bucket
1. Take out the flat bucket and holding frames from
the box.
Fig.22
► 1. Flat bucket 2. Holding frame
2.
Assemble the holding frames by tightening 12
bolts.
Fig.23
► 1. Bolt
1
2
1
3. Remove the cord cover located in the lower right
corner on the rear of the machine.
Fig.24
► 1. Cord cover
4.
Place the holding frames on the base unit, and
then temporarily tighten 2 bolts at the rear of the
machine. Tighten the rest of 4 bolts securely, and then
tighten 2 bolts at the rear of the machine securely.
1
Fig.25
► 1. Bolt (front) 2. Bolt (rear)
16 ENGLISH
1
2