Putting Into Operation; Periodical Maintenance - IARP EIS112.3 CL Instructions D'emploi Et D'entretien

PUTTING INTO OPERATION

Check that the voltage on the iden-
tification plate is the same as that of
the network.
THE ELECTRICAL SUPPLY LINE
TO WHICH THE REFRIGERATOR
WILL HAVE TO BE CONNECTED
IS TO BE PROTECTED BY A VERY
SENSITIVE DIFFERENTIAL SWITCH
(Rc=16A,Dc=30mA); IT IS ALSO TO BE
LINKED TO THE GENERAL EARTHING
PLANT.
Earthing is necessary and compulsory by
law. Absolutely never use reduction units,
patch cords, adapters or multiple socket
outlets to connect the counter.
DIRECTLY connect the equipment to the
mains.
The manufacturer disclaims all responsability for any damage to people or things due to incorrect
observance of this rule.

PERIODICAL MAINTENANCE

Any further adjustments on the refrigerator necessarily require the electric plug to be removed.
Check periodically the supply cable in order to detect any damage.
If the power supply cable is damaged, don't use the equipment and don't try to repair it: to prevent any
risk, it must be replaced by the manufacturer, by a member of the after-sales service staff, or anyway
by a person having similar qualifications.
In any case, none of the protective elements (the grill, the carter) must be removed by non qualified
staff. Absolutely avoid using the refrigerator without such protection.
The replacement of lamps must be carried out only by an Authorized Service Center.
The lamps have to be replaced by identical lamps only.
For a good preservation of the cabinet's body a periodical cleaning is necessary.
EXTERNAL BODY: When necessary, the external body should be cleaned with a cloth and a neutral
soap and water solution.
STAINLESS STEEL SURFACES: Wash with warm water and mild detergent, rinse well and dry
with soft cloth. Avoid scouring pads etc. which will spoil the finish of the stainless steel.
SURFACES IN PLASTIC MATERIAL: Wash with warm water and mild detergent, rinse well and
dry with soft cloth; under no circumstances should alcohol, methylated spirits or solvents be used.
GLASS SURFACES: Only use products specifically designed for glass cleaning; It is not advisable
to use ordinary water which can leave a film of calcium on the surface of the glass.
-9-