Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Problems
There is no steam. The appliance has not been
The steam flow
is low.
Water runs
through the holes
of the steambrush.
The steamer takes
a long time to heat.
If it is not possible to establish the cause of the problem, seek the assistance of
an pproved ROWENT Service Center www.rowenta.com
Possible causes
turned on.
The hose has been
obstructed.
There is no water left.
Your steamer has a build-
up of scale because it has
not been rinsed out regu-
larly.
There is no water left.
There is condensation in
the hose.
Your steamer has a build-
up of scale because it has
not been descaled regu-
larly.
Solutions
Check that your appliance is properly
plugged in and press the On / Off button
(on the front of the appliance).
The power light should turn on.
Check that the hose is not bent or twis-
ted.
Turn off the appliance and refill the
water tank.
Descale the steamer at least once a year
or every 50 hours of use. If your water is
hard, increase the frequency.
Turn the appliance off and refill it.
Never use steamer in a horizontal posi-
tion. Hold the hose vertically outstret-
ched and wait for water to flow back into
the steamer.
Rinse out the steamer at least once
a year or every 50 hours of use. If your
water is hard, increase the frequency.
11
Publicité
